Frequently asked questions Coldstream FTO PLUS water filter elements
Find answers to frequently asked questions about Coldstream FTO PLUS filter elements here. These are also supplemented from time to time. All answers are based all information from the manufacturer's knowledge base, additionally supplemented by our own experiences.
Use
The Coldstream FTO PLUS filter elements are easy to install, use and clean. Priming is not required and no additional filters are needed to remove fluoride. Before installation, just rinse the outside briefly under the cold tap and, if necessary, sand lightly with an abrasive sponge to remove all production dust.
Installation
Follow the roadmap below:
- 1. Take the filter element and place rubber ring on the stem.
- 2. Insert the handle through a hole in the top tray.
- 3. Tighten the wing nut on the underside of the upper tray. If you feel resistance, that is enough. Do not overtighten. Repeat steps 1 and 2 for any other filter elements.
- 4. Seal any remaining holes with blocker plugs.
- 5. Place the upper tray on top of the lower tray.
- 6. Fill the upper container with water and allow the water to drain. We recommend using the throw away first 2 cycles!
Cleaning, maintenance and storage
We recommend cleaning the Coldstream FTO PLUS filter elements once a month, as well as the containers and other parts of your water filter. However, if you notice a difference in the taste/odour of the water and/or experience a delay in the flow rate earlier, this may indicate that your filters need cleaning.
Cleaning
CAUTION: DO NOT use soap when cleaning a filter element. Make sure NO water gets into the stem of the filter element.
It is important that no water gets into the blue stem of the filter element. So hold the filter element by its base and hold it under cold running water for about 2 minutes. While water continuously flows over the filter element, lightly scrub the white ceramic exterior with a scouring pad. Rinse well and set aside until ready to reinstall.
Replacement
Lifetime: 1,500 litres or 6 months. Whichever occurs first. Of course, it is difficult to keep track of the number of litres, which is why we always recommend simply keeping to 6 months. No matter how many Coldstream FTO PLUS filter elements you use, all should be replaced after 6 months.
If during those 6 months you notice a difference in the taste/odour of the water and/or experience a slowdown in the flow rate, this may indicate that your filters need cleaning. If after cleaning, the filter speed does not increase or you still notice the same taste/odour, then it is time to replace the filter elements.
English (UK) 
Nederlands 
Deutsch 
Français 
Español